Etc Source Four LED v1.6.0 User Manual Bedienungsanleitung Seite 71
- Seite / 100
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
3 Operation 65
Recalibrate Fixture
Service technicians may use this option to calibrate the constant current driver electronics
for the LEDs. The calibration process goes through each series of LEDs, starting at 0
intensity and stepping up to 100%. The calibration is automatic and takes a few minutes.
During this time, do not exit the screen until it is complete.
Step 1: On the Diagnostics screen, scroll to Recalibrate Fixture.
Step 2: Press [].
Step 3: When asked if you are sure, select Yes and press [].
Figure-3.36 LED Calibration Screen with Calibration in Process.
Step 4: Press [] or [] to return to the Diagnostics screen.
About Fixture
The About screen displays the following information. This is a read-only screen.
• The software version number
• The fixture serial number
• The assigned fixture RDM number
• The color bias of the LED array
Figure-3.37 About Fixture screen.
Step 1: On the Diagnostics screen, scroll to About Fixture.
Step 2: Press [].
Step 3: Press [] or [] to return to the Diagnostics screen.
CAUTION:
This calibration process does not measure or recalibrate the light output of the LEDs.
Under normal use, it is not necessary to recalibrate the fixture, and doing so will likely
have no beneficial effect on fixture performance. It is therefore NOT recommended
to recalibrate the fixture without express instruction from an authorized technician.
LED Calibration
LED 1 .......Pass
LED 2 .......Pass
LED 3 .......Pass
LED 4 .......Working
LED 5 .......Working
LED 6 .......Working
LED 7 .......Working
Diagnostics
Recalibrate Fixture
This Will Calibrate
LED Array
Are You Sure?
Yes
No
About Fixture
RDM: 6574:12345678
Ver: 1.5.0.0.0.05 (0)
Ser: 000021xxx
Desire Lustr+ 22
DMX START: 001
RDM Label
- User Manual 1
- Table of Contents 3
- Chapter 2 4
- Chapter 3 4
- Appendix A 5
- Appendix B 5
- Introduction 7
- Daylight and Tungsten 8
- Fixture Components 9
- Applications 10
- Document Conventions 10
- WARNING: 11
- Contacts 12
- Chapter 1 13
- Specifications 14
- Typical Power Consumption 15
- Note About LED Fixtures 16
- Hardware 17
- Install Lens Tube 18
- Aim Adjustments 19
- Focusing the Beam 20
- Shaping the Beam 20
- Soft Focus Diffuser 21
- CAUTION: 23
- Adjusting the Yoke Position 24
- Installation Clearances 25
- Safety Cable 27
- Fixture Weight 27
- Connections 29
- DMX Profile 30
- Color Mixes 31
- HSI and HSIC: 31
- Color Matching 33
- Direct Control 34
- Fan Control 34
- Tungsten and Daylight 35
- Installing Accessories 36
- Basic Menu Navigation 37
- User Interface Overview 38
- 2 Basic Menu Navigation 33 39
- Keypad Lockout 39
- Lustr+ screen shown 40
- Display Title 41
- Input Settings 41
- DMX Address 41
- Menu Navigation 42
- Operation 43
- Home Screen Displays 44
- 3 Operation 39 45
- Main Menu 46
- Operation 41 47
- Advanced Menu 48
- Data Loss 50
- HLL-2Min 50
- HLL-4ever 50
- Using Plus Seven Control 51
- Regulated 52
- Protected 52
- Standard 53
- Incandescent 53
- Output Freq 55
- Red Shift 55
- Operation 51 57
- Fade Time 58
- Delay Time 58
- []. To discard 59
- Edit (Daylight and Tungsten) 60
- Copy to Other Fixtures 60
- Save DMX as Preset 61
- Sequences 62
- Operation 57 63
- Link Time 64
- Finishing the Sequence 64
- Master/Slave Operation 66
- Current DMX In 67
- Network Statistics 68
- Operation 63 69
- Individual Control (Ind Cntl) 70
- Recalibrate Fixture 71
- About Fixture 71
- Backlight 72
- BLght time out 72
- Language 73
- Status Indicators 73
- Operation 69 75
- Studio Settings 76
- 3 Operation 71 77
- Studio DMX Control 78
- Error Messages 79
- Software Updates 80
- Routine Maintenance 81
- Quick Start 83
- Configure 84
- Quick Setups Menu 85
- Studio Quick Setup 86
- Advanced Settings 86
- Menu Flow Chart 87
- System OK 88
- Menu Flow Chart 83 89
- Menu Flow Chart 85 91
- Press the Light Bulb button 93
- Lustr+ and Studio HD xtures 93
- To Te s t 94
- To Recalibrate 94
- Menu Flow Chart 89 95
- B Menu Flow Chart 91 97
Verwandte Produkte und Handbücher für Beleuchtung Etc Source Four LED v1.6.0 User Manual
(1 Seiten)
(100 Seiten)
(7 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.066 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern