Etc LED Configuration Software Programming Guide Bedienungsanleitung PDF herunterladen (Seite 7)

1 Operation 4

Overview

LED Config runs on a computer that can be connected to the DMX/RDM network via

Gadget or a DMX/RDM gateway. After the fixtures are configured, Gadget or the gateway

can be disconnected and a DMX/RDM lighting control device can be connected to the

network for continued operation.

Figure-1.1 Architecture of using LED Config Tool to configure fixtures on a network.

NOTE:

LED Configuration software should be installed prior to attaching Gadget or a gateway to

the computer to ensure that the Windows driver is installed.

Gadget or a gateway should be connected to the PC before running Configuration

software.

Up to 32 fixtures

Gadget

Console

DMX/RMD network

PC with LED Configuration software

DMX/RDM

gateway

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Keine Kommentare

Etc LED Configuration Software Programming Guide Bedienungsanleitung Seite 7