Etc LED Configuration Software Programming Guide Bedienungsanleitung

LED Configuration SoftwareProgramming Guidev1.0Rev ARead entire User Manual before using equipment.LED Config Tool by ETCCopyright © 2013 Electronic T

7 LED Configuration Software 1.0 Programming GuideQuick SetupsSelect a fixture in the Discovered Devices pane and then click one of the Quick Setups t

1 Operation 8HomeThe Home pane displays a summary of the current configuration of the selected fixture. Figure-1.5 Home pane for the XT Arch Setup.Sta

9 LED Configuration Software 1.0 Programming GuideAdvanced SettingsUse the Advanced Settings tab to customize the default settings of the Quick Setup

1 Operation 10Data LossSelect the type of data loss. Data Loss is what happens to the fixture's output when the external control signal (either D

11 LED Configuration Software 1.0 Programming GuideNOTE:Once any one of the seven individual color channels is altered from its neutral starting posit

1 Operation 12CurveCurve is the correlation between the change in the value of the dimming control signal and the actual change in the fixture's

13 LED Configuration Software 1.0 Programming GuideOutput FrequencyOutput Frequency is the frequency in Hz at which the LED array pulses, or blinks, a

1 Operation 14Status IndicatorsStatus Indicators are on by default. Select Off to turn the Status Indicators off.Figure-1.8 Status Indicators on the b

15 LED Configuration Software 1.0 Programming GuideStatusThe Status tab displays LED temperatures and fixture messages and errors of the selected fixt

1 Operation 16Presets and SequencesUse the Presets and Sequences tab to run a preset color mix or a sequence of presets in a stand-alone operation whe

ETC permits the reproduction of materials in this manual only for non-commercial purposes. All other rights are reserved by ETC.ETC intends this docum

17 LED Configuration Software 1.0 Programming GuideDelay Time Delay time is the length of time the fixture waits on the previous setting before initia

1 Operation 18Vivid, Lustr+, Fire and Ice, and Studio HD PresetsThe Desire Series Vivid, Lustr+, Fire and Ice, and Studio HD fixtures come with 24 def

19 LED Configuration Software 1.0 Programming GuideSequencesA Sequence is a timed series of Presets. Up to 12 different Sequences may be altered for P

1 Operation 20End StateAfter each of the steps have been configured, set the End State. End state is what the fixture does once it completes the Seque

Corporate Headquarters  3031 Pleasant View Road, P.O. Box 620979, Middleton, Wisconsin 53562-0979 USA  Tel +608 831 4116  Fax +608 836 1736London,

LED Configuration Software 1.0 Programming Guide iTable of ContentsIntroduction . . . . . . . . . . . . . . . . . . . . . . . . . . 1Applications . .

1 LED Configuration Software 1.0 Programming GuideIntroductionCongratulations on your purchase of LED Configuration software. LED Config Tool is insta

Introduction 2ContactsIf you have questions about your LED Configuration software that are not answered in this manual, please contact the supplier of

3 LED Configuration Software 1.0 Programming GuideChapter 1OperationThis chapter contains the following sections:• Overview. . . . . . . . . . . . . .

1 Operation 4OverviewLED Config runs on a computer that can be connected to the DMX/RDM network via Gadget or a DMX/RDM gateway. After the fixtures ar

5 LED Configuration Software 1.0 Programming GuideLED Config Tool Interface The LED Config Tool interface window consists of panes and tabs. Each disp

1 Operation 6Discovered DevicesWhen the computer is connected to the network or via USB and the connected fixtures are turned on, LED Config Tool disc