Etc Source Four CE Mini Bedienungsanleitung PDF herunterladen (Seite 10)

Replacing the Lamp

WARNING:

Allow the lamp housing to cool before replacing the lamp.

CAUTION:

RISK OF FIRE - Use an MR16 lamp rated at 50 Watts or less.

CAUTION:

DRY LOCATIONS ONLY.

Note:

It is recommended to use an MR16 lamp with a nominal beam

angle of 38 degrees.

Step 1: Disconnect power to the Source Four Mini before installing the lamp.

Step 2: Loosen the brass lamp housing knob on the back of the lamp housing. The

knob is not captured so it may come loose from the luminaire.

Step 3: Pull the lamp housing away from the luminaire body.

Step 4: Pull on the lamp carefully to remove it from the lamp housing.

Step 5: Gently push down on the

replacement lamp until it is seated in

place.

Step 6: Re-align the housing into the grooves

of the luminaire.

Step 7: Align the knob with the hole, and

tighten the lamp housing knob.

Lamp housing

knob

1 2 ... 5 6 7 8 9 10 11 12

Keine Kommentare

Etc Source Four CE Mini Bedienungsanleitung Seite 10