Etc Source Four CE jr and jr Zoom Assembly Guide Bedienungsanleitung PDF herunterladen (Seite 13)

CE Source Four jr / jr Zoom Assembly Guide 13

Shutter assembly

Tools required: None

1. Place the bottom divider plate (2) on a flat surface.

Note: The notches on the divider plates must line up with each

other.

Warning: Divider plate edges are sharp. Handle with caution!

2. Place two shutter blades (1) on top of plate (2), handles facing

outward.

Note: Install shutter blades with the rounded sides facing the

same direction.

3. Place the middle divider plate (3) on top of the two shutter

blades.

4. Place the two remaining shutter blades (1) on top of the middle

divider plate.

Note: The third and fourth shutter blades should be at 90˚ angles

to the first and second.

5. Place the top divider plate (4) on top of the third and fourth

shutter blades.

6. Install the four springs (6) onto the nips on the spring plate

support (5).

7. Place the dimples of the plate divider (4) onto the open ends of

the springs.

Figure 12

Figure 11

1 2 ... 8 9 10 11 12 13 14 15 16

Keine Kommentare

Etc Source Four CE jr and jr Zoom Assembly Guide Bedienungsanleitung Seite 13