Etc Desire Series v1.6.0 User Manual Bedienungsanleitung PDF herunterladen (Seite 13)

Quick Start 7

Quick Start

This section details the steps for a quick fixture setup.For more comprehensive information,

see Operation, page 45.

Install

Step 1: Hang or mount the fixture using the provided hardware and approved hardware

accessories.

Step 2: Attach an approved safety cable when applicable.

Step 3: Insert secondary lenses with the smooth side out, if desired.

Step 4: Insert additional accessories (top hat, egg crate, etc.) into the holder, if desired.

Connect (D40, D40XT, D60)

Step 1: Attach the power cable to the Power In connector.

Step 2: Attach 5-pin XLR cable to the DMX In connector (if using external control).

Step 3: Plug the power cable into AC power (100 to 240VAC, 50/60 Hz) on a

non-dimming circuit.

Step 4: Plug the XLR cable (if using) into the DMX source or data daisy-chain.

Step 5: Link additional fixtures via the Power Out and DMX Out connectors using the

following guidelines.

• No more than nine total D40 or D40XT fixtures on Power Thru.

• Up to 32 device loads on the DMX daisy-chain.

Connect (D22 Portable)

Step 1: Attach 5-pin XLR cable to the DMX In connector (if using external control).

Step 2: Plug the power cable into AC power (100 to 240VAC, 50/60 Hz) on a

non-dimming circuit.

Step 3: Plug the XLR cable (if using) into the DMX source or data daisy-chain.

WARNING:

• Do not link more than nine fixtures when using Power Thru (non-dimming,

100 to 240 VAC, 50/60 Hz). Power Thru is not available on all Desire

Series fixtures.

• Up to 32 devices can be daisy-chained together per data run.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 99 100

Keine Kommentare

Etc Desire Series v1.6.0 User Manual Bedienungsanleitung Seite 13