Etc SmartFade v3.0.1 Bedienungsanleitung PDF herunterladen (Seite 77)

7 DMX Backup 71

Backup memories

The backup memories are recorded by connecting the DMX output of an external console

to the DMX in port of your SmartFade console when it is started in Backup Mode.

Preparation

Step 1: Set DMX In:To Memory. See “DMX In” on page 70.

Step 2: Connect the DMX out of the external console to DMX in of your SmartFade

console.

Step 3: Bring up Fader 1 (or Last) to allow DMX In. See “DMX In” on page 70.

Step 4: Make sure the Grand Master is at full, and that BLACKOUT is off.

Record a Backup Memory

Set up a look you want to record in the console connected to DMX In.

Test memory

Bring down the fader controlling DMX In. Move the fader of this memory up. The same look

you recorded should appear on stage. The light in the bump button of the fader will be

dimmed to show that it has content.

Clear Levels

Clear may be used to clear output levels.

Action Console Feedback

1. Activate recording Buttons that can record in this mode will blink

at full. If there is a memory stored already,

this button is dimmed (press CLEAR to exit).

2. Select fader ... or

...

The moment the bump button is pressed, the

memory is stored. Press UNDO to undo this

recording.

Action Console Feedback

Clear levels from one

memory

and ...

The selected fader is set to zero. Bring the

fader down and back up to restore.

Clear all levels and All faders and the Stack is set to zero. Bring

the faders down and back up to restore.

Clear all levels All faders and the Stack is set to zero. Bring

the faders down and back up to restore.

REC

MEM

CLEAR

MEMS

CLEAR

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 83 84

Keine Kommentare

Etc SmartFade v3.0.1 Bedienungsanleitung Seite 77