Etc Eos v1.3 Bedienungsanleitung PDF herunterladen (Seite 312)

298 Eos Operations Manual

Multi-console setup

When using multiple Eos consoles on the network, you should adjust some of the settings of your

Eos devices to ensure optimal functionality.

Designate Master

By default, all Eos devices will boot as a master. When using multiple Eos devices on the network,

only one should be designated as a master. Other Eos devices should be configured as the backup

(only one per system) or clients. There can be a maximum of 12 Eos devices connected to a

master.

To change this setting, you must exit the Eos software (Browser>File>Exit Eos) and then

designate the Eos device as master, backup, or client as described in the ECU appendix (see

Starting Screen, page 286).

DHCP Server

DHCP server supplies IP addresses to network devices. Only one Eos device [typically the Primary

(Master)] on the network is necessary to do this properly. Therefore you should disable the DHCP

server on all Eos devices except for the intended primary.

To disable the DHCP server on your Eos device see (Eos) IP Settings, page 293.

Change Device Name

To easily identify your Eos on the network, change the device name to be representative of the

device (such as “Booth Primary” or “Tech Backup”). This is done in General Settings, page 288.

Note:

It is recommended that you perform the following setting changes before

connecting your Eos device(s) to the network. After the changes are complete,

connect to the network and reboot the device.

1 2 ... 307 308 309 310 311 312 313 314 315 316 317 ... 355 356

Keine Kommentare

Etc Eos v1.3 Bedienungsanleitung Seite 312